Use and care

According to technical data sheets, the nylon and fluorocarbon threads used for the bracelets can withstand a maximum load of 7 kg and 14 kg respectively. Steel cables can even reach values of up to 20 kg. However, damage to the crimp beads or the clasp can occur beforehand, especially if the jewelry gets caught or snagged and breaks as a result.

It is imperative that the size of the bracelet fits your wrist.

To find out the right size for a bracelet, simply measure your wrist circumference and add about 1.5 to 2 cm. The measurement can be done either directly with a tape measure or indirectly by measuring the circumference of the wrist with a non-stretchable thread on a ruler.

The ideal size is achieved when a finger fits easily between the bracelet and your wrist.

To know if a bracelet is the right size, make sure that the functional length is equal to your ideal size . If the bracelet has a chain extension, the functional length can be smaller than your ideal size. It is always more aesthetic if the Extension chain is about 1 cm too long . The loose end then hangs down.

Instructions for use and care for metallic elements

The deterioration of the coating is recognizable by a tarnishing of the surface and a subsequent discoloration of the piece of jewelry combined with the background showing through. This is mainly due to the Effect of friction in combination with the oxidation of alloying elements.

To maintain the lifespan of your jewelry, whether coated or not, the following points must be observed:

  • Do not expose the jewelry directly to household products, cosmetic products (e.g. oils, emulsions, creams, etc.) and perfume. These can oxidize the metal.
  • Do not wear jewelry during physical exertion or in extreme heat to avoid sweat, which oxidizes the metal due to its acidity.
  • Do not wear your jewelry in the shower to avoid contact with aggressive soaps, which can oxidize the metal.
  • Do not wear jewelry while sleeping to avoid friction.
  • Do not wear jewelry in chlorine-rich environments such as swimming pools or the sea. Chlorine can be aggressive to certain metals and cause them to oxidize. It is important to note that salt contained in sea water, but also in sand, is particularly abrasive and causes the coating to erode
Despite all the care, it is possible that your gold-plated jewelry will be damaged on parts that come into contact with the skin, especially on the knot covers or clasps. If your skin is particularly acidic, this degradation is inevitable. To remedy this, I recommend applying a special transparent jewelry varnish relatively frequently to protect the surface of the affected parts.

Jewelry should be cleaned with mild soap and water and then dried thoroughly.

When jewelry is not worn, it must be stored individually, protected from moisture and light.

Instructions for use and care for pearl jewelry

Glass beads and mineral beads are fragile and can be damaged by impact or friction. It is therefore recommended not to wear glass bead and mineral jewelry during physical exertion or while sleeping.

It is important to point out that some minerals are sensitive to water ( e.g. B. malachite, apatite, prehnite, etc. ) or direct sunlight ( e.g. rose quartz, amethyst, turquoise, etc. ).